Instructions for Installation & Use
- Series No. JS8A/2010
19
HOW TO INSTALL
E.
Engage seatbelt buckle and tongue. Push
down on the seat (with knee or hand),
whilst pulling the sash belt firmly to tighten
the seatbelt. This will make the lap belt
very tight across the restraint. Whilst
holding the seatbelt tension, ensure to
remove all slack from lap part of seatbelt
by pulling sash belt. For inertia/retractable
seatbelts, allow excess belt to feed back
into the retractor.
Car Seatbelt
Remove all slack
from lap portion,
then sash
Engage
seatbelt.
Feed through
seatbelt path
NOTE:
Some vehicle seats have more
rearward slope than others. Use a rolled
up towel or padding under the seat
for contoured vehicle seats to prevent
excessive recline.
If the car seatbelt does not remain tight,
then contact your local fitting station, or
Safe-n-Sound customer service for a
gated 3-bar slide (order No. 0215).
Rolled up
towel under
the base
Rolled up
towel at
the back
Push down
on the seat
FORWARD FACING
WITH BUILT-IN HARNESS
