Instructions for Installation & Use
Instructions for Installation & Use
30
31
INSTALLING INTO A VEHICLE
WITH SEATBELT. (REARWARD
FACING)
A. Position restraint rearward facing in the chosen
seating position in the car where a child
restraint anchor fitting is installed.
B. Loosen shoulder straps by pressing the
harness adjuster and pull both shoulder straps
evenly. Pull out the desired amount of slack.
Undo the buckle and place buckle tongues in
the Harness Tongue Holders on each side of
the cover.
C. Remove padded insert (if supplied), and
gently lift headrest trim end, then pull
backwards the centre panel flap, with the
comfort pad from the inner seat of trim.
The seat shell inner and belt path label are
now exposed.
Harness
Tongue
Holders
HOW TO INSTALL USING SEATBELT
HOW TO INSTALL USING SEATBELT
A
Pull
Press
D. Fully lengthen seatbelt and feed through
the blue
REARWARD FACING
BELT PATH
opening, between the
restraint cover and the restraint shell
following the belt path label and through
seatbelt slots in the opposite side of the
restraint.
E. Engage seatbelt buckle and tongue.
Push down on the restraint, whilst pulling
all the slack through the seatbelt tongue
into the sashbelt strap. Pull sashbelt firmly
and feed any slack back into the retractor.
The lap belt will be firmly fitted across the
restraint.
Always remove slack from seatbelt
A loose seatbelt is dangerous.
NOTE: Seatbelt buckle and tongue must
not rest between restraint cover and
restraint. If seatbelt buckle is adjustable,
adjust buckle as low as possible away
from the restraint.
Push and
remove slack