Instructions for Installation & Use
Instructions for Installation & Use
26
27
36
ISOFLEX CONNECTORS (IF SUPPLIED)
31. ISOFLEX Strap Adjuster Button
32. ISOFLEX Connector Release Button
33. ISOFLEX Connector Indicator
34. ISOFLEX Connector
35. ISOFLEX Adjustment Strap
36. Tension Indicator (Green when activated )
IS THERE ENOUGH ROOM
To ensure that the space is sufficient, the
purchaser should check the measurements
between the vehicle’s rear and front seats in
which the child restraint is intended to be used.
DO NOT USE RESTRAINT IN REARWARD FACING
MODE WITHOUT THE STABILISING BAR FULLY
EXTENDED.
Do not use the restraint without the top tether strap
correctly attached.
DO NOT USE A REAR FACING CHILD RESTRAINT
WHERE AN AIRBAG IS FITTED IN FRONT OF THE
SEATING POSITION.
Do not use on any vehicle seat which faces sideways or
rearwards.
CHILD RESTRAINT UPPER ANCHORAGE FITTING
To use this child restraint, the car will need a child restraint upper anchorage fitting in the seating position
that you intend to use. Refer to the car owner's handbook.
If no upper anchorage fitting is provided then you will need to install an upper anchorage fitting. Refer to
pages 93 to 96.
The upper anchorage fitting is required for attaching the top tether in both rear facing mode and forward
facing mode covered later in the these instructions.
Do not allow the front seat to alter
the installed angle of the restraint. It
is permissible to allow the restraint to
touch the front vehicle seat.
FEATURES: REARWARD FACING
SUITABLE FOR USE
32
33
34
35
31
375mm
520mm
Seat width 450mm