Britax MARATHON CLASSIC, Руководство пользователя

Страница: 32 / 48

30
Installation: Versa-Tether
®
Using the Versa-Tether
1 Consult your vehicle owner’s manual for
designated tether anchorage locations.
2 Locate the tether on the rear of the child seat
and remove the tether from the pouch.
3 Place the tether up and over the child seat
back.
4 Install the child seat using the LATCH system or
the vehicle belts according to the instructions
in this manual.
5 Tilt the tether release tab then pull to fully
extend the tether strap into a “V” shape.
6 Locate the hook on the strap and attach the
tether hook to the vehicle’s designated tether
anchor.
• See figure A for a forward-facing installation.
• See figures B and C for a rear-facing
installation.
IMPORTANT: The tether should be hooked over,
not under, the vehicle tether anchor.
7 Pull the tether adjuster strap to remove all
slack. Roll up excess webbing and store in
tether pouch.
8 Verify there is tension in the tether strap and
that child seat is properly secured.
• The child seat is secure when it cannot be
moved front-to-back or side-to-side more than
1 in. (2.5 cm) at the belt path.
NOTE:
• The rear-facing recline angle of the child seat should be 30º– 45º from
vertical (not to exceed 45º) when car is parked on a level surface (Figs.
B and C).
• Do NOT use the Versa-Tether to achieve this angle. The rear-facing
recline angle can be adjusted by placing a rolled towel or pool noodle
in the vehicle seat bight.
OR
A
OR
b
C