46
47
Turn and slide the retainer
6
through the slot to remove.
Pull the harness webbing tight
*
from the other side before
pulling the retainer through.
Repeat steps 5 and 6 for the
remaining harness buckle strap.
Remove the locking screw
7
from the head restraint
adjuster and insert into the
shell to store.
IMPORTANT:
Store the screw in
the slot provided in the shell. Store
all parts of the harness in a safe
place. These parts will be needed
to convert the child seat back to
harness mode.
Pull the harness straps out of
4
the slots.
DO NOT remove the HUGS™
*
chest pads or chest clip.
On the bottom of the seat,
5
slide the retainer of one
harness strap up and pull it
away from the child seat shell.
This seat may only be used in booster mode with children who
stand 42 – 65 in. (106.7 – 165.1 cm) in height and weigh more than
40 lbs (18.2 kg). Britax recommends booster mode only after the
child outgrows harness mode.
Harness to Booster Mode
To remove the harness and buckle:
Loosen the harness.
1
Press release lever
a
Pull both harness straps forward
b
Remove the belt shield and
2
unhook the harness straps from
the yoke.
Replace the belt shield (a) then
3
store the yoke in the slot (b).
Locking
Screw storage
Switching Between Modes
Switching Between Modes
