5
Installation
1 .
Determine Installation Location
A .
Place the dispenser upright�
B .
Locate the dispenser on a hard, level surface that is out of direct
sunlight and near a grounded wall outlet� Allow dispenser to sit for
30 minutes to allow condenser to settle�
NOTE:
DO NOT plug in the power cord yet�
C .
Position the back ofthe dispenser at least 8 in� (20 cm) from a
wall to permit free airflow between the wall and water dispenser�
2 .
Install the Drip Tray and Grid
A .
Remove drip tray and grid from packaging material� Insert grid into
drip tray, then slide drip tray into dispenser until it is securely in place�
3 .
Connect a Water Bottle
IMPORTANT:
To prevent dry heating, DO NOT turn on the heating
and cooling switches until you complete the steps in
this procedure�
NOTE:
This dispenser is compatible with 3- and 5-gallon water
bottles (purchased separately)� DO NOT use hard water as
it may adversely affect functioning of the dispenser�
A .
Remove the plastic wrapping and cap from the water bottle and wipe
down the new bottle with a clean cloth�
B .
Open the cabinet door and feed the bottle adapter tube into the water
bottle� Ensure the tube hits the bottom of the bottle�
C .
For a 5-gallon bottle, place the bottle adapter over the neck of the
water bottle and press securely into place�
D .
For a 3-gallon bottle, press down on the two tabs on top of the bottle
adapter and slide the cap down the probe tubing to adjust the bottle
adapter to fit�
E .
Slide the water bottle into the dispenser cabinet and close the door�
Plug in dispenser�
NOTE:
Water will not pump from the bottle unless door is closed�
F .
Wait 5 minutes for the water tanks to fill with water before using
the dispenser�
G .
Before dispensing water, air must be removed from the water
tanks� Place a cup or container under the water dispense point�
Simultaneously press the hot and cold water buttons, and allow
water to dispense until it runs steadily and without air�
