BRINKMAN CJWINTER 192 Series, Инструкция по эксплуатации

Страница: 12 / 17

CJWinter Page 12
Shifting the Size Adjustment Range
The 192 series head is designed with an ample adjustment range, while
maintaining the ability to make small, precise changes. If you run out of
adjustment when setting your part size, the range can be shifted upwards or
downwards to accommodate your particular part and roll diameter
combination. The steps required to shift the range are as follows:
1. Remove the Front Plate (#1), Knurl Rollers ,
Thrust Washers (#11 & #22), Thrust Bearings
(#10) and the Carbide Bushings (#5) from the
body of the tool.
2. Place the tool face DOWN (Shank UP), on a
workbench.
3. Loosen the three hex head bolts (#9)
approximately a 3/16" (3 turns) using a 9/16
open end wrench.
4. Twist the head relative to the
shank, until the graduated
scale on the side reads
approximately ZERO.
5. Lay the tool on its side, and
slide the Shank (#6) back
away from the Center Plate
(#3) approximately 3/16".
6. Using a .070" pin or wire,
insert the pin into one of the
three gear timing holes in
the Center Plate (#3), and
twist the size adjustment
slightly until the pin drops
between a gear tooth and
locks the head.