BRINKMAN CJWINTER 192 Series, Инструкция по эксплуатации

Страница: 11 / 17

CJWinter Page 11
Pre-Setting the Knurl Diameter
New knurl rolls may vary in diameter somewhat from batch to batch, and from
new to used. When installing new rolls, the easiest way to pre-set the knurl
size is to use a previously knurled part, inserted between the 3 knurl rollers,
and pinch down on that part using the head size adjustment. To adjust the
diameter, follow these steps:
1. Loosen the three hex head bolts (#9) a 1/2 turn using a 9/16 open end
wrench.
2. Twist the head of the tool relative to the shank. The graduated scale on
the side will tell you if you are adjusting the part size up or down.
3. Lock the size by tightening the three hex head bolts.
Note: When running the knurls with little to no backlash, it is advisable
to add backlash by loosening the Adjusting Sleeve (#14) before adjusting
part size downward. This will avoid binding the knurls on the master
pinion gear. After size has been adjusted and locked, reset the Adjusting
Sleeve (#14) position so the rollers just rotate freely, and lock this
adjustment as well.