BRIGHT OTF 5000, Инструкция по эксплуатации

Страница: 25 / 48

OTF 5000/HS/LS-001/2/3/4 Iss 4 June 2012
19
1 Slacken the anti-roll T piece clamp screw (16) and slide the angle adjustment shaft
backwards and forwards until approximately 2/3 of the anti-roll plate stem is below the anti-
roll T piece clamp screw. Then tighten the anti-roll piece clamp screw.
2 Next slacken the anti-roll height clamp screw (18) and turn the anti-roll micro adjusting knob
until the edge of the anti-roll plate is very slightly below the edge of the knife but exactly
parallel to it.
3 Tighten the screw (14) and have screw (12) lightly screwed down so that screw (13) can still
be turned.
4 Place the roll plate against the knife and start to cut sections again. They will curl up over the
roll plate.
5 Slowly turn the anti-roll micro-adjusting knob (17) clockwise while cutting sections. When the
plate (15) reaches the correct height, the sections will start to go under the plate.
6 Tighten all the screws then flip the plate away from the knife by operating the anti-roll plate
adjuster (19). Now flip the plate back into position. When cutting is resumed, sections should
go under the plate as before, i.e. the plate has aligned itself. If not, repeat the setting up
process.
Do not drag the anti-roll plate downwards across the edge of the knife as this will result in
possible damage to both the anti-roll plate and the knife.
Your anti-roll plate may vary from the design shown, but the set-up procedure remains the
same. Please refer to section 3.6, A Problem Solving Guide, for further assistance.