13
7. Reinstall spray tip into spray wand.
8. Reconnect spray wand to spray gun.
9. Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray
gun and pump. Turn on water.
10. Plug power cord into electrical outlet and turn the
master ON/OFF switch to the pressure washer ON (I)
position.
11. Test pressure washer by operating with each quick
connect spray tip.
Pump and Motor Maintenance
The electric pressure washer does not require any
maintenance to the pump or motor. Both assemblies
are pre-lubricated and sealed, requiring no additional
lubrication ever.
After Each Use
Water should not remain in the unit for long periods of time.
Sediments or minerals can deposit on pump parts and
“freeze” pump action. Follow these procedures after every
use:
1. To ensure detergent tank does not drain during
storage, run electric pressure washer with soap spray
tip until tank is empty.
2. Add 0.5 liter of clean fresh water to detergent tank,
run electric pressure washer with the black detergent
spray tip. Flush for one or two minutes.
3. Turn master ON/OFF switch to OFF (0) position.
Remove power cord plug from electrical outlet.
4. Turn off water supply. Point gun in a safe direction,
press trigger lock button and squeeze trigger to relieve
trapped pressure.
5. Disconnect garden hose from water inlet. Disconnect
high pressure hose from spray gun and high pressure
outlet.
6. Drain water from hose and spray gun, then use a cloth
or equivalent to wipe off all exterior surfaces.
7. Drain water from pump by tipping unit onto its right
side (water inlet facing down) for two minutes. Flip
unit over and let rest on high pressure outlet for an
additional two minutes.
8. Coil power cord and high pressure hose around hook.
9. Store spray gun in spray gun holder. Store spray
wand in spray wand holder. Store spray tips in holder
provided on the spray wand. See
Features and
Controls
and
Final Storage Procedures
.
10. Store unit in a clean, dry area. The unit can be stored
in vertical or horizontal position.
11. If storing for more than 30 days see
Winter or Long
Term Storage
.
Winter or Long Term Storage
Follow steps 1-9 in
After Each Use
.
NOTICE
Water left in pump could freeze and permanently
damage pump. Freeze damage is not covered under
warranty.
Protecting the Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver, Model 6039, to treat
pump. This prevents freeze damage and lubricates plunger
and seals.
NOTICE
PumpSaver is available as an optional
accessory. It is not included with the electric pressure
washer. Contact the nearest authorized service center to
purchase Pump Saver.
NOTICE
You must protect your unit from freezing
temperatures.
• Failure to do so will permanently damage your pump
and render your unit inoperable.
• Freeze damage is not covered under warranty.
To use PumpSaver, make sure electric pressure washer
is turned off and inlet and outlet hoses are disconnected.
Read and follow all instructions and warnings given on the
PumpSaver container.
Final Storage Procedures
1. Coil power cord and high pressure hose around hook.
2. Store spray gun in spray gun holder. Store spray
wand in spray wand holder. Store spray tips in holder
provided on the spray wand. See
Features and
Controls
and
Final Storage Procedures
.
3. Store unit in a clean, dry area that is protected from
freezing temperatures. The handle can be folded
down for storage. The unit can be operated in vertical
or horizontal positions.
4. Cover unit with a suitable protective cover that does
not retain moisture.