14.Set time/strike master timer
15.
Updating .
Choose main menu option 12 (Updating). Select from
the sub
-
menu the device or clock that must be updated.
Install the device and the master will update the selected
software in the device.
Attention: To use this function, the Club
-
Master must
have been updated. This is done by connecting the
master to a PC with the BCE programme, which gives an
automatic update from the internet.
16. Updating the ETS devices.
When the Club
-
Master is connected to a computer that has internet access and the BCE programme
loaded onto it, the latest software for the ETS clock will be loaded automatically into the master.
The new software for the ETS clock can then be loaded directly onto each clock from the master
using the master menu option 12 (updating).
Attention: Updating of the software will only occur if there is a new version available.
Don't disconnect the master from the PC or shut down the PC whilst making the download.
1. Set time
2. Strike Master Timer
Connect the Bricon radio
-
frequency controlled clock
(see 4
-
6) and the printer.
Press 1 and the master system will synchronise with the
time on the radio
-
frequency clock.
The printer will then automatically produce a print
-
out to
confirm this synchronisation.
Connect the radio
-
frequency clock and the printer.
Press 2
‘
Strike Master Timer
’
if you wish to make a
strike of clocks against the radio clock, at any point in
the minute before that at which you wish to strike.
A countdown will then commence ten seconds before
the top of the minute with a beep heard every second,
and on the whole minute another sound will be heard as
a signal for the strike to take place.
Press OK for the printer to produce a record of the strike.
Start count
BRICON CLUB
-
MASTER
34
