Wall mount install manual body 04-25-07.doc
7
The shroud mounts at the top of the Treadwall, and the printed
surface will be vertical.
Place the ladders as shown, and lift the shroud to the top of
the channels.
Bolt it onto the top bearing holes with 1/2" bolts.
Proximity switch:
A bracket with a black wire, shipped with the
magnets and counter-timer in the parts box.
Attach the proximity switch
inside the top of the left
channel using the top rear bolt of the large square bearing.
Place the 3 magnets
on the shaft. The magnets stick to the
shaft by magnetic attraction. Adjust the magnets until the
center of the magnets pass under the proximity switch with a
1/8" gap.
Bring the wire
down the inside of the channel through the
clips and out through the hole near the counter-timer. Plug
in the wire.
See page 15 for details
.
Turn the shaft
by pulling down the chains a few times to
test the Counter-timer It should register one foot each time
two
magnets pass the switch.
Panels:
Putting on the
panels
is tedious but goes better if you are
organized.
Check the chains again to make certain that they are still
synchronized. (If you find that the chains are not synchronized
when the panels are partly on, call us. We have a quick fix.)
Tools:
A VSR battery-operated drill with an adjustable clutch and a #2
Phillips bit.
A 3/8” wrench – either a small socket or combination wrench.
Install a reinforcing channel
(“stiffy”) onto the back of each
panel before bolting to the chains. The stiffy slips into the
holes when properly aligned.
If the stiffy is a tight fit, you can place the panel face down
on the floor and step on the stiffy to push it into place.
Attach the stiffy.
On the front of the panel there is one hole
near the middle of the that does not have a flat 'island'
around it. There is a bag of short round-head bolts in the
hardware box. Screw one of these bolts through this special
hole to hold on the stiffy.
Definition
