Bresser Temeo Hygro Quadro DLX, Инструкция по эксплуатации

Страница: 21 / 28

21 / 28
3. The device is energized directly.
4. Wait until the indoor temperature is displayed on the base station.
NOTICE! When switching from mains power supply to battery power supply or vice versa,
the power supply is being disabled for a short moment for technical reasons. In this process
all settings made previously, will be deleted.
Remote sensor
1. Loosen the screws at the battery compartment cover with a small Philips screwdriver and remove
the cover.
2. Insert the batteries into the battery compartment. Ensure that the battery polarity (+/-) is correct.
3. Set the channel selector switch to the desired channel.
NOTICE! This weather station can be operated with up to 3 remote sensors. Each remote
sensor being connected must be operated on a different channel. If only one remote sensor
is connected, it should be operated on channel 1.
4. Replace the cover and retighten it with the screw.
9 Automatic time setting
After the power supply was established, the clock will automatically search for the radio signal. This
will take approximately 3 to 8 minutes to finish this process.
If the radio signal is received correctly, the date and time will be set automatically and the radio control
signal icon turns on.
If the clock fails to receive the time signal, go ahead with the following steps:
1. Press and hold the DOWN button for approx. 2 seconds to re-initialize radio signal reception.
2. Is the device still not receiving the signal, the time must be set manually.
Read the detailed manual for more information about manual time and alarm time settings (see down-
load information on page 2).
10 Manual time setting
1. Press and hold MODE button for approx. 3 seconds to change to time setting mode.
2. Digits to be set are flashing.
3. Press UP or DOWN button to change the value.
4. Press MODE button to confirm and continue to the next setting.
5. Settings order: Year > Month > Day > Weekday Language > 12/24-hours mode > Time zone offset
> > Hours > Minutes
6. Finally press the MODE button to save the settings and exit the setting mode.
11 Alarm setting
1. Press MODE button to switch to the setting mode for the alarm time.
2. Press UP button to activate or deactivate the alarm.
3. Press and hold MODE button for approx. 3 seconds to enter the alarm time setting mode.
4. The value to be set flashes.
5. Press UP or DOWN button to change the value.
6. Press MODE button to confirm and continue to the next setting.
7. Settings order: Hours > Minutes > Snooze interval (01-20 minutes)
8. Finally press the MODE button to save the settings and exit the setting mode.