8
3. INSTALLATION AND GETTING STARTED
3.1 WIRELESS 7-IN-1 SENSOR ARRAY
1. Antenna
2. Rain collector
3. UVI / light sensor
4. Mounting pole
5. Mounting base
6. Balance indicator
7. Wind cup
8. Radiation shield
9.
Wind vane
10. Red LED indicator
11.
[ RESET ]
key
12. Battery door
13. Mounting clamp
14. Rain sensor
15. Tipping bucket
16. Drain holes
2
3
6
1
4
5
7
9
8
12
13
14
11
15
16
10
3.1.1 INSTALL BATTERIES
Unscrew the battery door at bottom of unit and insert the
batteries according to the +/- polarity indicated.
Screw the battery door compartment on tightly.
NOTE:
-Ensure the water tight O-ring is properly aligned in place to
ensure water resistant.
-
The red LED will begin flashing every 12 seconds.
3.1.2 INSTALL MOUNTING POLE
Step 1
Insert the top side of the pole to the square hole of the
weather sensor.
NOTE:
Ensure the pole and sensor's indicator align.
Step 2
Place the nut in the hexagon hole on the sensor, then
insert the screw in other side and tighten it by the
screw driver.
