Bresser 7003500, Инструкция по эксплуатации

Страница: 59 / 100

60
3.1.4 WIRELESS 7-IN-1 SENSOR ALIGNMENT
Install the wireless 7-IN-1 sensor in an open
location with no obstructions above and around the
sensor for accurate rain and wind measurement.
Install the sensor with the smaller end facing the
North to properly orient the wind direction vane.
Secure the mounting stand and bracket (included)
to a post or pole, and allow minimum 1.5m off the
ground.
Point to
NORTH
1.5 meter
off the
ground
Fixed pole
package not
included
Add rubber
pad before
mounting on
pole or post
Install the wireless 7-IN-1 sensor in an open location with
no obstructions above and around the sensor for accurate
rain and wind measurement. Install the sensor with the
smaller end facing the North to properly orient the wind
direction vane. Secure the mounting stand and bracket
(included) to a post or pole, and allow minimum 1.5m off
the ground.
Add rubber
pad before
mounting on
pole or post
1.5 meter
off the
ground
Fixed pole
(not included)
Point to
NORTH
3.2 WIRELESS HYGRO-THERMO SENSOR
1. Transmission status LED
2. Wall mounting holder
3. Channel slide switch
4. Reset
5. Battery compartment
1 2
3
4
5
3.2.1 INSTALL WIRELESS THERMO-HYGROMETER SENSOR
1. Remove the battery door of the sensor.
2. Use the channel slide switch to set the channel number for the sensor (e.g.
Channel 1)
3. Insert 2 x AA size batteries into the battery compartment and close the
battery door according to the polarity information marked on the battery
compartment.
4. The sensor is in synchronization mode, and can be registered to the console
within the next few minutes. The transmission status LED will begin to flash
every 1 minute.