39
EN
3.2 Insert the SD-card*
Insert an SD card into the camera before you start ope-
rating the camera. (Camera's power switch is in the OFF
position). Open the camera. Insert SD-card into the card
slot with the unmarked side facing upwards. Please note
that the SD-card can only be plugged in in one direction.
Make sure that the write-protect switch of the SD-card
is in the “write” position; otherwise the camera can not
take images or videos.
3.3 Power on the Camera
Before switching on, please pay attention to the fol-
lowing:
1. Avoid temperature and motion disturbances in front of
the camera such as big leaf, curtain, air-conditioner,
air outlet of a chimney or other heat sources to pre-
vent false triggering.
2. The height from ground for placing the camera should
vary with the object size appropriately. In general, one
to two meters are preferred.
3. Slide the power switch to the ON position to power
on the camera.
After switching on the camera, the indicator LED (red)
will blink for about 10s. The 10s is a buffering time be-
fore autonomic capturing of photos or videos, e.g. for
closing and locking the bottom cover, fi xing the camera
on a tree and walk away.
3.4 Enter into the TEST Mode
In order to use custom settings, the camera of the TEST
mode must be activated. Slide to the main switch on the
position "OFF" in the "SETUP" position.
Various functions such as user-specifi c settings or ma-
nual recording can then be controlled via the six button
keypad.
The camera does not turn on when there is no SD card
is inserted.
3.4.1 Manual capturing
In TEST mode it is easily possible to capture pictures or
videos manually by pressing the
“OK”
button.
*not included with your purchase
