28
Chapter 4: Assembling the Bed Face Panel unit.
Position the middle support stiffener
first, centered evenly between the
“Mechanism End” and the “Leg End”
and attach with screws from hardware
card #7.
Position the other two support stiffeners, centered
between the middle stiffener and the bed ends and attach
with screws from hardware card #7.
STEP 4
FIG. 4H - OVERHEAD VIEW
FIG. 4G - OVERHEAD VIEW
STEP 3
Critical Step
Position the frame
1/2” from
“Mechanism End” and centered
along the left and right sides
.
Attach frame to doors using
screws from hardware card #7.
We highly recommend using a bit
holder and a #2 square drive to insert screws. When
attaching screws, attach the 4 corners first, which will
help keep the frame aligned. The position of the frame
over the doors is crucial, so double check alignment as
you insert screws.
Full, Queen and King beds: Make sure the doors are
pushed together so there’s no gap between the doors
and they are even on the ends. It can be helpful to add
a strip of tape between the doors.
If you have trouble with screws being inserted at an angle or improperly, using a
bit holder
on your drill will keep your screws vertical and use a
#2 square drive
to
prevent screws from breaking or camming out.
For video instructions of this specific chapter, visit:
breda.us/frame
FIG. 4I - KING SIZE BEDS
King size beds have an extra 2
stiffeners for added strength.
Position these 2 extra
stiffeners against the Leg End
rail as shown in Fig. 4I.
STEP 5
King Beds Only
Be careful not to cover handle holes with stiffeners.
