Operation Manual IQ-MOTOR-eco GPS
5
1.1.1
Instrument Switch-on
The instrument is switched-on by pressing the
On/Off
key.
To prevent unintentional switch-on, it needs to be acknowledged
upon display prompt:
Switch-On?
by pressing the
OK
key.
Following acknowledgement the display will shift for approx.
15 sec. to the
switch-on display screen
with following
information:
-
Battery state, serial number, pilot’s name, instrument type and
-
Software (Firmware) Version.
After switch-on the normal flight screen shall appear with flashing altitude data display. The
device needs approx. two minutes to calculate the precise 3D-GPS position. As soon as
the GPS receives stabilised altitude data, the
pressure altimeter is automatically adjusted
,
the altitude data display stops flashing and the symbol
GPS
appears over the GPS data display.
1.1.2
Instrument switch-off / stop flight recording
For switch-off the
On/Off
key needs to
be pressed until the question:
Switch-
off?
Press
OK
is prompted
on the
screen.
Again, to prevent unintentional switch-off, also this action needs to
be acknowledged by pressing the
OK
key!
1
. If no flight recording has been programmed, the instrument is
immediately switched-off following acknowledgement by
OK
.
2
. Following an active flight recording the read-out screen
Flight
– Analysis
is displayed during 60sec. before switch-off.
If you want to quit the flight analysis display early,
press shortly the
Off-
key,
the instrument will then be switched-off immediately.
3
.
Automatic switch-off:
the flight analysis appears
automatically after landing and shall be displayed for about
60sec. Without key stroke the IQ-BASIC-GPS is switched-off
automatically.
4
.
Automatic switch-off at non-use
If the device does not detect a keystroke or flight related
parameters during 30 minutes, it will be switched-off
automatically.
Switch-On ?
Press OK !
Test Batt.
2.86 V
Switch-off ?
Press OK !
End recording?
Switch-off ?
Press OK !
