will only dissociate that sensor from the current relay. Any other assignments will remain in
effect.
Assigning Relays
In order for a relay to display its information, it must be assigned to a zone. To assign a relay,
go to
Settings > Zone Settings > Zone #
. Then tap “Add Relay to Zone”. This will bring up the
Relay Map
to display all currently configured relays. If a relay icon is green, that relay can be
added to a relay. If a gray relay icon needs to be added, go back to
Settings > Relay Map
and
follow the instructions for “Adding/Removing Relays”. Each relay can be assigned to only one
zone. To remove a relay assignment, press and hold the relay icon for 5 seconds. Then select
“Remove”. Relays will retain sensor assignments and settings when assigned to another
zone.
Assigning Analog Outputs
To select which zone provides the value to use for the analog output, navigate to
Settings >
Zone Settings > Zone #
. Then select “Analog Output”. In the pop-up window, choose which of
the available analog outputs to use. Each analog output can only be assigned to one zone.
Each zone can be assigned multiple analog outputs. To remove an analog output assignment,
IOM03
Rev 1.1 – May 18, 2021
34
