62
English
3. Clean it and remove any debris or insects.
4. Replace the collector when it is clean and completely dry.
Cleaning the hygro-thermal sensor
1.
Remove the two screws at the bottom
of the guard.
2. Remove the safety guard carefully.
3. Carefully remove any dirt or insects on
the sensor housing. Do not allow the sensors inside to become wet.
4. Clean the shield with water to remove dirt and insects.
5. Replace all the parts when they are clean and completely dry.
Caution!
16. Safety instructions and disclaimer
Never try to open the device to repair or make modifications. Avoid con
-
tact with the mains voltage. Do not short-circuit the product. The device
is not waterproof, hence please use it only in dry surroundings. Protect it
from high humidity, water and snow. Keep the device away from high tem-
peratures. Do not expose the device to sudden changes in temperature or
strong vibrations, as this could damage the electronic components. Check
the device for any damage before using it. The device should not be used
if it was subject to impact or has been damaged in some other manner.
Please comply with the local regulations and restrictions.
