40
English
Inserting the batteries
Open the battery compartment cover un
-
derneath the sensor and insert the batteries
according to the indicated polarity.
Replace the battery compartment cover
tightly.
Caution!
Ensure that the waterproof O-ring is proper-
ly in place to ensure water tightness.
The red status LED flashes once in 12 sec
-
onds when the device is working.
Assembling the stand (outer sensor)
1. Insert the top of the rod into the
square hole of the L-sensor at the
bottom.
Note: Make sure that the mast and the
sensor displayed are aligned.
2. Place the nut into the hexagonal hole
of the sensor, then insert the screw
from the other side and tighten them
using a screwdriver.
3. Insert the other end of the rod into
the square hole of the plastic stand.
