Installation
MF2944/BIR3
Bradley •
2215-1373 Rev. P; ECN 14-00-006 6/6/2014 5
3
Install Pedestal
Remove molding strips or tiles which could
prevent a flush mounting to the wall.
MOUNTING
PANEL
LOWER
BRACKET
CENTERLINE
PEDESTAL
ASSEMBLY
FLOOR ANCHOR
LOCATION
WALL ANCHOR
LOCATION
A
Measure and mark the centerline of the washfountain
on the wall and floor .
B
Before mounting the pedestal to the floor, make sure
the floor is level . If it is not level, be prepared to install
shims when positioning the pedestal in Step C .
C
With someone to assist you, move the pedestal
assembly to the wall using appropriate lifting
procedures, and align the locating notches on the
mounting panel with the centerline marked on the
wall . If the floor is not level, install shims under the
left and/or right pedestal .
D
Drill holes in the wall through the four 1/2" diameter
holes in the mounting panel and install four anchors
(supplied by installer) for
3
/8" bolts .
E
Secure the pedestal assembly to the wall anchors
using four
3
/8" bolts and washers (supplied by
installer) .
F
Drill holes in the floor through the two 1/2" diameter
holes in the lower bracket and install two anchors
(supplied by installer) for
3
/8" bolts .
G
After floor anchors are installed, secure the pedestal
assembly to the floor anchors using two
3
/8" bolts
and washers (supplied by installer) .
