Bradford BALBOA M3, Руководство по установке и эксплуатации

Страница: 29 / 50

Residential Spa
pg. 29
File: RES_Hottub_manual_021116
Testing Your Spa Set Up
Instruction Card for M-2 and M-3 systems equipped with Deluxe Digital control panels.
Control Panel Pads
Temperature Adjustment (80°F–104°F)
Press either pad once, and the LCD will display the set temperature, as well as the words “SET HEAT.”
Each time either of these pads is pressed again, the set temperature will increase or decrease.
After three seconds, the LCD will automatically display the current spa temperature.
Aux (button for optional equipment)
This button NOT USED on our standard 1 or 2 pump system.
Light
Your spa light has one setting. After 30 minutes, the light will automatically turn off.
Economy & Standard Modes
Press this pad to switch between modes. Standard mode maintains the set temperature at all times.
Economy mode heats the water only during filter cycles. See the Optional Filter Cycle Programming
section for more heater options.
Jets 1 Lo-Hi
The operating sequence for the pump is low speed, high speed, then off. If left running, the low
speed will automatically turn off after 30 minutes; the high speed will turn off after 30 minutes.
The low speed runs when the heater is turned on, when a filter cycle is activated, or when a freeze
condition is detected. When the low speed turns on automatically, it cannot be deactivated from the
panel; however, the high speed may be started. For single speed pump, pressing the 2nd button will
reflect no change.
Jets 2 Hi
This pad turns the spa’s second set of jets on and off, if equipped. If left running, the jets will
automatically turn off after 30 minutes.
Automatic Features
Preset Filter Cycles
Your spa will automatically filter itself twice each day. The low speed of the pump and the Ionizer
(Typ.) will run the duration of each filter cycle.
Filter 1
The first filter cycle is automatically activated at 8:00 PM and operates the low speed of the pump
and the Ionizer (Typ.) until 10:00 PM. Again, if the heat enable feature is on, the spa will heat to the set
temperature in the economy mode. The blower will run for 30 seconds to clean out the air channel.
Filter 2
The second filter cycle is automatically activated at 8:00 AM and operates the low speed of the pump
and the Ionizer (Typ.) until 10:00 AM. If the heat enable feature is on, the spa will heat to the set
temperature in the economy mode.