Bradford BALBOA M3, Руководство по установке и эксплуатации

Страница: 20 / 50

Residential Spa
pg. 20
File: RES_Hottub_manual_021116
Installing Your Spa
Installing the Spa (cont.)
2. Check around the steel frame at the bottom of the spa. Each leg of the stainless steel frame
must contact the ground directly.
3. If the concrete pad is not level, use a pry bar to lift the spa frame and insert stainless steel
shims to make the spa level.
Remote Equipment Only - Making Spa, Equipment Pack, and Power Source Connections
Make all connections between the spa and equipment pack before connecting the equipment
pack to the main power source. You will need to make the following connections:
1. Connect water temperature sensor
2. Install freeze sensor
3. Connect the equipment pack to power source
4. Make plumbing connections and fill with water
5. Connect bonding, light, and spa-side control wires
Remote Equipment Only - Connecting Water Temperature Sensor
CAUTION: Always route sensor wires away from high-voltage lines.
To connect the water temperature sensor:
1. Locate the labeled wire on the equipment pack.
2. Pull the water temperature sensor wire from the equipment pack to the spa through
the conduit using a fish tape.
3. Connect the wire to the water temperature sensor on the spa. See (figure 6).
Figure 6 : Water Temperature Sensor wire