Bradford White 100T199, Инструкция по установке и эксплуатации с руководством по устранению неисправностей

Страница: 11 / 60

11
Installation Instructions continued-
Figure 3b - Recommended Minimum Clearances For Service Access
Remove Crate
1. Remove all banding and pry off crate sides carefully as to NOT damage the water heater.
2. Carefully roll/lift the water heater from the crate base.
CAUTION
DO NOT drop water heater. DO NOT bump water heater jacket against floor.
DO NOT bump exhaust vent pipe against crate or other objects. This will damage the heater and cause it
to be inoperable or create nuisance problems.
Move Water Heater To Permanent Position
1. Move the water heater to permanent position by sliding or walking.
2. Place drain pan underneath water heater.
Install Temperature And Pressure Relief Valve
(if not already installed)
DANGER
Temperature setting should not exceed safe temperature at fixtures. See water temperature control warning in
Section V: Water Connections (page 15). If higher preheat temperatures are necessary to obtain adequate
booster output, add an ASSE approved mixing device for hot water supplied to fixtures.
WARNING
Temperature and pressure relief valve discharge piping must be piped near floor to eliminate potential
of severe burns. DO NOT pipe in any area where freezing could occur. DO NOT install any shut-off
valves, plugs or caps to the temperature and pressure relief valve or piping.
CAUTION
If the building cold water supply has a back-flow preventer, check valve or water meter with check valve,
provisions for thermal expansion of water in the hot water system must be provided.