3. Installation
Image 3-14
Warning:
Please consider the following rule to de
fi
ne an adequate screw length depending on the
mounted components:
Standard length: 13mm
Rubber cap: add 2,5 mm
Stand/handle: add 3 mm
VESA arm: add VESA plate thickness
Tip:
The display mounted on the stand can be screwed to the table by using the available holes in
the stand.
Warning:
Pay attention that none of the cables gets pinched between the display and the stand/handle
while mounting the display on the stand/handle.
Warning:
The protection against ingress of water IP33 will be void when installing the display without
the rubber cap.
To mount the display on a VESA arm
1. Mount the display
fi
rmly to the arm using 4 M4 screws.
Depending on the arm’s VESA standard (75 mm or 100 mm), different mounting holes on your display
should be used.
Warning:
Please consider the following rule to de
fi
ne an adequate screw length depending on the
mounted components:
Standard length: 13mm
Rubber cap: add 2,5 mm
Stand/handle: add 3 mm
VESA arm: add VESA plate thickness
Warning:
The monitor VESA mounting interface has been evaluated by quali
fi
ed Certi
fi
cation Bodies
with a safety factor 6, yet the stability of the overall system mounting solution will have to be
evaluated by the system integrator in the
fi
nal medical system con
fi
guration.
Warning:
The protection against ingress of water IP33 will be void when installing the display without
the rubber cap.
Warning:
The protection against ingress of water IP33 will be void when installing the display with the
cable routing expansion clip removed from the connector compartment cover. This is required
for displays mounted on a VESA arm without internal cable routing provisions.
(451920611082)K5902070 MSMD-1119 & MSMD-1119-TS 05/12/2013
15
