Bracco ACIST CVi CMS2000, Руководство пользователя

Страница: 53 / 92

About the T
ouchscreen
P/N 900468-001 Rev. 02 ACIST Medical Systems, Inc. Section 4 Touchscreen 39
• LAST INJECTION: Indicates the volume and highest fl ow
rate achieved during the most recent injection.
System Info
Located in the bottom right corner of the screen, this box displays
the company logo and system model number. If you repeatedly
touch this area of the screen you can scroll through the following
data:
• Hardware
Con fi guration, including Board ID, Control Panel ID.
• Software Con fi guration, including the software version and
fi rmware version.
• Current Session Info, including case number and the number of
manifold valve failures with this syringe.
• Number of power ups and total cases since the NVRAM
(memory) was cleared.
Audible Indicators
Audible indicators are used to notify you of certain conditions. The
audible indicators are identi
fi ed in the table below
Type of Message Event Audible Indicator
System Messages Start Re fi ll Series of tones to alert
user
Warning
Messages Re fi lling Repeating click
Injecting Repeating click
Warning is
displayed Beep
Touchscreen
Messages Touchscreen key
is pressed Click
X-Ray Interface Parameters
The following x-ray parameters are available on the Voyager and
CVi (peripheral mode) models:
•
INJECT DELAY and X-RAY DELAY
Inject Delay is used with the “injector start” input to delay the
beginning of the injection. X-Ray Delay is used with the “X-ray
trigger out” output and is used to delay the operation of the
X-ray equipment until after an injection has begun. These two
parameters are mutually exclusive, meaning you can de
fi ne
values for one or the other (but not both). Valid values for these
two parameters are 0 - 99.9 seconds.
X-ray imaging systems (such as GE, Toshiba) may handle the
delay functions directly. Always refer to the X-ray manufacturers’
user manual for instructions
• X-RAY SYNC
This button allows you to specify whether the imaging system
interface is enabled or disabled. This allows the system to be
controlled by the imaging system or by the hand controller
without disconnecting the interface cable. Repeatedly press this
button to toggle between Xray Sync On and Xray Sync Off.
System Information
X-Ray Sync
Inject Delay
X-Ray Delay
System Information and X-ray Interface Parameters