64
10. Using a #2 Phillips screwdriver, remove the indicated screw from the
Rear Shroud.
11. Carefully remove the Rear Shroud from the machine. Place a standard
screwdriver behind and near the middle of the Rear Shroud and gently pry
until it releases. Then move the screwdriver to the bottom and gently pry
until the Rear Shroud comes off.
12. Remove the indicated Caps from the machine.
13. Using a #2 Phillips screwdriver, remove the indicated (by oval) screw
and only loosen the lowest indicated screw (arrow) from the Left Fan
Cover.
14. The Left Fan Cover Assembly has a tab that needs to be pushed
upward to clear the loosened screw. While pushing up on the tab, remove
the Left Fan Cover Assembly.
15. Remove the Left Fan Cover Assembly from the machine. Be sure to
note how the fan screens are set into the Left Fan Cover to assist with the
replacement procedure.
16. Using a #2 Phillips screwdriver, remove the 2 indicated (by ovals)
screws from the Crank Cover. Repeat on the other side of the machine.
17. Remove the Crank Covers from the machine.
18. Place a rag or protective material below the Connector Arm to protect
the Shrouds from potential scratches from the Connector Arms.
19. Using a 6mm hex wrench, remove the hardware (indicated by arrows)
that connects the Connector Arms and the Pivot Arms.
Note:
The Connector Arm will pivot downward if not lowered slowly onto
the rag protecting the Shrouds
Rear Shroud
Cap
Cap
Crank Cover
Pivot Arm
Connector Arm
