Bowa ERGO 300, Инструкция по применению

Страница: 21 / 52

Instructions for use, ERGO 300 - BOWA- IFU-12930- ERG0300-S0-EN-20210701 21
Functional check
• Check Morcellator for loose parts
• Check that Morcellator is correctly assembled
• Are all labels easily readable?
• Check cutting tube: cutting tube evenly ground, no broken edges or bends?
• Switch on control unit
• Switch on motor (press pedal).
• Run motor with Morcellator for about 20 seconds; it must reach the set speed.
• If it does not run evenly, switch off motor with Morcellator.
• Switch off control unit
The control unit will only operate if the pedal has been connected to the control unit.
• Check that Morcellator is correctly assembled.
• Check that the gear unit runs smoothly; if necessary treat it with NouvaOil care spray.
• Check that the motor is clean and runs smoothly; if necessary treat it with NouvaOil care spray.
• Repeat the function check
Problem: the motor becomes very hot. Cause: the motor was damaged during preparation.
Remedy: do not continue to use the motor. Always have a spare motor available .
5.3.3 Mounting a grasping forceps (according to option 3 )
Grasping forceps are available in various designs. The gripper shown here is not supplied with the Morcellator set; it is an
optional accessory. Detailed instructions for assembly and preparation are included with the gripper.
5.4 Mains connection
Risk of electric shock
Connect the device to an earthed AC mains system that conforms to IEC guidelines only. Connect the device to a power
supply that corresponds to the connection values on the type plate on the back of the device.
Risk of damage
Do not switch on the control unit and the other equipment until all cables have been connected. Otherwise the equip-
ment may be damaged.
The device is not water-proof
Keep the device away from liquids. Keep the mains connection socket dry. Do not use the device if liquid penetrates it.
Connecting the power cable
• Switch off the power switch on the back of the device (“O” position).
• Plug the included power cable into the socket on the back of the device.
• Plug the other end of the power cable into the power socket