Bowa ERGO 300, Инструкция по применению

Страница: 30 / 52

30 Instructions for use, ERGO 300 - BOWA- IFU-12930- ERG0300-S0-EN-20210701
6.3 After use
1. Switching off
Switch the device off using the power switch at the back of the device (“O” position on the power switch) .
2. Removing protective tube (when using Morcellator with protective tube)
Rotate protective tube to „NO CUT“ position.
Close the proximal opening of the gear unit with the thumb to prevent gas loss.
Hold the protective tube and carefully disconnect gear unit with cutting tube and remove from patient.
The protective tube can also be removed from the percutaneous access.
If applicable, remove any other instruments.
3. Removing cutting tube (when using Morcellator with Trocar Cannula)
Close the proximal opening of the gear unit with the thumb to prevent gas loss.
Hold the Trocar Cannula and carefully disconnect gear unit with cutting tube from the Trocar Cannula and re-move from
patient. The valve flap closes automatically as soon as the cutting tube is pulled out.
The Trocar Cannula can remain as access throughout the remaining procedure.
4. Disconnecting gear unit connections
Pull the motor coupling from the gear unit’s motor
connection.
Pull the motor device connection plug from the motor
connection of the control unit.
Pull the motor out of the handle.
Lift and hold the release lever of the handle.
Pull the handle from the gear unit’s motor connection.
5. Disconnecting pedal connections
Pull the pedal device connection plug from the pedal
connection of the control unit.
6. Preparing for preparation at the location of use
Take the product to the preparation area immediately.
Prepare the product as specified in this manual.