Livewell
The 240 Outrage is equipped with an
18 Gal. (68.14L) livewell bucket that
is located under the hatch on the aft
port side of the sterndeck. The livewell
systems primary function is to keep
baitfish alive by circulating seawater into the livewell
bucket. The raw water pump, seacocks and plumb-
ing that service the system can be reached through
the access hatch located on the lower aft wall inside
the console. Fittings connected to the livewell bucket
and the livewell bucket seacock can be reached
through an access panel located on the front surface
of the livwell.
OPERATION:
The livewell can be filled by using the switch marked
LIVEWELL on the instrument panel. Before fill-
ing the livewell, you must make certain the hull
seacock and the livewell seacock are in the open
position. The livewell also has a pair of drain plugs
that are used to adjust the amount of water that stays
in the livewell. There is a plug(8) that will drain the
entire livewell located in the base of the livewell,
the other plug(7) can be used between the two over-
flow fittings on the starboard side of the livewell.
/,9(:(//
6<67(0
1
Livewell Lid
2
18 Gal. (68.14L) Livewell
3
Livewell Bucket Fill
4
Access Cover
5
Livewell Flow Control Valve
6
Raw Water Supply from Pump
7
Livewell Bucket Strainer, (2)
8
Livewell Bucket Plug
9
Tank Overflow Fitting, Upper Level
10
Tank Overflow Fitting, Mid Level
11
Livewell Light
12
Livewell Bucket Drain
13
Drain Fitting
14
Raw Water Supply to Livewell
15
500 GPH Livewell Pump
16
Livewell/Raw-water Seacock
Seacock
OPEN Seacock
CLOSED
Standard Livewell System Diagram
Section 6 - Bilge System
240 Outrage-Owners Manual
28
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
(This view is of item 16
looking aft, to show the
seacock).
The livewell seacock located behind the cover in the
aft section of the console interior, must be in the OPEN
position before using the livewell. Damage to the pump
could occur if it is closed when operating.
NOTICE
!