
5-9
Section 5 • Care & Maintenance
R
170 Montauk
• Disconnect the battery cables (negative
cable
fi rst).
• Remove the battery from the boat.
• Clean the terminal ends of the cables and battery
teminals with a solution of baking soda and
water. Rinse thoroughly with clean water.
• Apply a coat of grease on the terminal ends of
the cables and the battery terminals.
• Store the battery in a cool, dry area.
• Use a trickle charger to keep the battery
c h a rg e d o r c h a rg e t h e b a t t e r y e v e r y
30-60
days.
Battery
Remove battery from boat and store in a cool,
dry location. Periodically check the battery
during storage.
NOTICE
Follow the manufacturer’s recommendations for
long term storage of your battery(s).
NOTICE
Electrical System
• Check all connections and tighten if
necessary.
•
Spray all connections with an anti-corrosion
spray.
Clean the deck with soap, hot water and a stiff brush
to clean up any oil spills.
Deck
It is important to raise the bow of the boat enough
to allow for proper drainage of water from the deck
and bilge area. Make sure all the drainage fi ttings are
clear and free of debris and plugs are removed. Store
the engine in an upright position to promote adequate
drainage of water.
Drainage
Remove any valuables or anything that can be easily
removed from the boat such as electronics, lines,
PFDs, fenders, cushions, etc. and store at home.
Avoid Loss
When covering your boat it is best to use a frame of
either aluminum or wood to keep the cover up. This
allows air to circulate and discourages water from
pooling on the cover.
Cover
NOTICE
DO NOT USE a bimini top in lieu of a cover.
Damage and aging will occur while providing
no protection for your boat.
Vents along the entire length of the cover will allow
condensation to escape. Placing a series of foam
pads between the hull and cover will also aid in air
circulation and reduce condensation.
To help keep your boat dry and mildew free, consider
placing commercial odor and moisture absorbing
products in the boat under the cover.
Repeatedly immersing the trailer in water during boat
launching can cause a variety of problems. Water
seeping into the wheel hubs will cause the grease to
emulsify and can prematurely corrode the bearings.
Check with the trailer manufacturer for scheduled
maintenence of your trailer.
Trailer Storage
Содержание 150 Super Sport
Страница 2: ......
Страница 54: ...2 22 170 Montauk Section 2 General Information R THIS PAGE INTENTIONALLY LEFT BLANK ...
Страница 70: ...4 6 170 Montauk Section 4 Electrical System Switch and Breaker Panel Schematic Fig 4 6 1 ...
Страница 82: ...5 12 Section 5 Care Maintenance R 170 Montauk THIS PAGE LEFT INTENTIONALLY BLANK ...