Boss Snowplow RT3 EXT, Руководство по установке

Страница: 9 / 32

Installing the Hydraulic
Hoses
Refer to Figure 9 when installing the hoses to the
hydraulic shelf.
g036650
Figure 9
1. C1 to the left push-frame
cylinder 5. C2 to the right push-frame
cylinder
2. Aux to the upper fitting on
the lift cylinder 6. L to the lower fitting on the
lift cylinder
3. XR2 to the outer fitting on
the right wing-cylinder 7. XR1 to the inner fitting on
the right wing-cylinder
4. XL2 to the outer fitting on
the left wing-cylinder 8. XL1 to the inner fitting on
the left wing-cylinder
1. Connect a 1.8 m (73-1/2 inch) hose to the XL2
port on the hydraulic shelf, and a 1.5 m (59-1/2
inch) hose to the XL1 port (
Figure 9 ). Turn the
fitting until it is finger tight, then turn it another
1/4 to 1/2 turn.
Important:
Do not overtighten.
2. Slide the 2 hoses through 2 pieces of hose wrap
as shown in
Figure 10 .
3. Secure the hoses to the left hose-clamp using a
bolt (5/16 x 2-1/2 inches) and nut between the 2
sections of hose wrap (
Figure 10 ).
4. Using thread compound, install 90° fittings to the
left wing extension cylinder (
Figure 10 ).
Note:
The fittings should point toward the
center of the plow.
5. Connect the 1.5 m (59-1/2 inch) hose to the
inner fitting on the left wing-cylinder (
Figure 10 ).
Turn the fitting until it is finger tight, then turn it
another 1/4 to 1/2 turn.
Important:
Do not overtighten.
9