Boss Snowplow RT3 EXT, Руководство по установке

Страница: 17 / 32

4. Connect the blue plug from the headlight adapter
to the blue plug on the long wire harness (
Figure
24 ).
5. Connect the free end of the headlight adapter to
the previously disconnected plug on the vehicle
wire harness (
Figure 24 ).
6. Repeat steps 1 through 5 on the right vehicle
headlight.
7. Continue the wire harness installation from step
5 of Installing the Wire Harness (page 13) .
For Four-Headlight Vehicles
1. Disconnect the wire harness plugs from the back
of the left vehicle headlights (
Figure 25 ).
g032933
Figure 25
1. Outer vehicle headlight 5. Blue plug
2. Headlight adapter 6. Headlight adapter
3. Inner vehicle headlight 7. Vehicle low-beam plug
4. Black plug 8. Vehicle high-beam plug
2. Connect the 2 ends of the headlight adapter to
the back of the left vehicle headlights (
Figure
25 ).
3. Connect the black plug from the headlight
adapter to the long wire harness (
Figure 25 ).
4. Connect the blue plug from the headlight adapter
to the blue plug on the long wire harness (
Figure
25 ).
5. Connect the free end of the headlight adapter to
the previously disconnected low-beam plug on
the vehicle wire harness (
Figure 25 ).
6. Grease, tuck, and secure the previously
disconnected high-beam plug on the vehicle
wire harness (
Figure 25 ).
Note:
You will not use this connector.
7. Repeat steps 1 through 6 on the right vehicle
headlights.
8. Continue the wire harness installation from step
5 of Installing the Wire Harness (page 13) .
Mounting the Plow
Controller
DANGER
The controller could cause serious injury if
contacted during a crash.
Mount the controller in a location where
vehicle occupants will not contact during a
crash.
Note:
Mount the controller in the cab in a dry area
where it does not interfere with vehicle operation or
visibility.
Important:
Do not install the swivel mount when
temperatures are below 16°C (60°F).
1. Determine the mounting location for the
controller.
2. Clean the location with the provided alcohol
wipe and dry it with a cloth or paper towel.
3. Clean the back of the swivel mount ( Figure 26 )
with the alcohol wipe and then dry it.
g032942
Figure 26
1. Swivel mount
2. Mounting tab
4. Remove the backing from 1 side of the adhesive
and apply it to the back of the swivel mount.
5. Remove the remaining backing from the
swivel-mount adhesive and press the swivel
mount to the clean area of the dashboard for 30
seconds.
Important:
Once the mount is placed, you
cannot remove it without destroying the
adhesive.
6. Clean the back of the controller with the alcohol
wipe and then dry it.
7. Remove the backing from 1 side of the adhesive
and apply it to the back of the mounting tab
(
Figure 26 ).
17