Boss Snowplow MSC13950, Руководство по установке

Страница: 6 / 12

g209502
Figure 14
1. Hoses 2. Cable tie
9. Route the loose end of the hose in the P port
(long 90° fitting) of the manifold between the lift
arm and frame (
Figure 14 ), and connect it to the
inner port on the hydrostatic drive ( Figure 13 ).
10. Secure the hoses to the frame using a cable tie
(
Figure 14 ).
11. Secure the hydraulic hoses away from moving
components or sharp edges using cable ties.
12. Attach the manifold cover to the hydraulic
manifold mounting bracket using 4 push
fasteners (
Figure 15 ).
g036944
Figure 15
1. Manifold cover 2. Push fasteners
Finishing the Installation
1. Install the previously removed hour meter.
2. Install the fuel tank if it was removed.
3. Start the machine; refer to your Grandstand
Multi Force
Operator’s Manual .
4. Use the controls to move the hydraulics in all
directions to cycle the hydraulic fluid.
5. With the hydraulic cylinder fully extended, shut
off the engine and wait for all moving parts to
stop.
6. Clean the area around the cap and the filler neck
of the hydraulic tank (
Figure 16 ).
g031401
Figure 16
1. Hydraulic-tank cap 2. Fill mark
7. Remove the cap from the filler neck, and add
fluid to the reservoir until it reaches the fill mark
(
Figure 16 ).
Important:
Do not use standard BOSS
hydraulic fluid in this system. Refer to your
Grandstand Multi Force
Operator’s Manual
for the appropriate hydraulic fluid.
8. Install the cap on the filler neck.
9. Repeat steps 4 through 8 .
Note:
The fluid level should be at the full mark
with the lift cylinder fully extended.
6