Troubleshooting
en
45
Fault
Cause and troubleshooting
The programme does
not start.
3.
If this display appears again, call customer service.
→
Note:
You can start the washing programme if you de-
activate the intelligent dosing system and dose manu-
ally.
The detergent drawer has not been pushed in fully.
▶
Push in the detergent drawer until the symbol goes
out.
The door cannot
be opened.
The temperature is too high.
▶
Wait until the temperature has dropped.
▶
"Cancelling the programme", Page 33
Water level is too high.
▶
Select a suitable programme for draining.
→
Power failure.
▶
Open the door using the emergency release.
→
The water is not drain-
ing.
Drain pipe or water outlet hose is blocked.
▶
Clean the drain pipe and the water outlet hose.
Drain pipe or water drain hose is caught or jammed.
▶
Ensure that the drain pipe and water drain hose are
not kinked or trapped.
Drain pump is blocked.
▶
"Cleaning the drain pump", Page 38
The water outlet hose is connected too high.
▶
Install the water outlet hose at a maximum height of
1 metre.
Detergent dosage is too high.
▶
Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
▶
If intelligent dosing is activated, reduce the basic
dosage →
.
▶
If you dose manually, reduce the amount of deter-
gent for the next washing cycle with the same load.
Unapproved extension installed on the water drain
hose.