en
Faults and what to do about them.
34
Faults and what to do about them.
Faults
Cause/Remedy
Water is leaking from the
machine.
■
Attach the drain hose correctly or replace it.
■
Tighten the screw fitting on the supply hose.
The machine is not filling
with water.
Detergent is not being dis-
pensed.
■
Have you pressed the
A
button?
■
Is the tap turned on?
■
Could the filter be clogged? Clean the filter.
■
Is the supply hose kinked or trapped?
The door cannot be
opened.
■
The safety function is activated. Stop the programme?
■
Is
$
selected (Rinse Stop = no final spin)?
■
Can the door only be opened by the emergency release?
The programme will not
start.
■
Have you pressed the
A
button or selected
Ready in
ñ
time?
■
Is the door closed?
■
Is the
E
childproof lock activated? Deactivate it.
The drum briefly jerks or
judders after the pro-
gramme has started.
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash programme starts.
The water is not draining.
■
Is
$
selected (Rinse Stop = no final spin)?
■
Clean the drain pump.
■
Clean the drain pipe and/or the drain hose.
Water is not visible in the
drum.
Not a fault – the water is below the visible area.
The spin result is not sat-
isfactory.
Laundry is wet/too damp.
■
Not a fault – the unbalanced load detection system has interrupted the spin
cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
■
Is
Easy-iron
p
selected (depending on the model)?
■
Is the selected speed too low?
The spin cycle runs sev-
eral times.
Not a fault – the unbalanced load detection system is adjusting an imbalance.
The programme is taking
longer than usual.
■
Not a fault – the unbalanced load detection system is adjusting an imbal-
ance by repeatedly distributing the laundry.
■
Not a fault – the foam detection system is active – a rinse cycle has been
switched on.
The length of the pro-
gramme changes during
the wash cycle.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown in the display
panel.
Residual water in the
care-product compart-
ment
i
.
■
Not a fault – the effect of the care product is not affected.
■
Clean the insert if necessary.