Bosch VeroCafe Latte TES503 Series, Инструкция по эксплуатации

Страница: 22 / 138

18 en
Robert Bosch Hausgeräte GmbH
N.B.:
If the water ilter is activated, the
display will prompt you to remove the
ilter and then press the
start
button (10)
again. Remove the ilter now if you have
not already done so. Press the
start
button (10).
Fill descaler
Press start
● Pour lukewarm water into the empty
water tank (16) up to the
0.5 l
mark and
then dissolve 1 Bosch descaling tablet
TCZ8002 in it. When using TCZ6002,
2 tablets must be dissolved.
● Press the
start
button (10).
Calc‘n‘Clean in progress
The descaling pro gramme will now run for
about 10 minutes.
Place container
Pull milk frother
● Place a receptacle with a capacity of at
least 1 litre under the outlet (6c).
● Pull the milk frother (6) to open it.
Calc‘n‘Clean in progress
The descaling pro gramme will now run for
about 12 minutes.
Clean / Fill water tank
Press start
● Rinse the water tank (16) and reill it with
fresh water up to the
max
mark.
● Press the
start
button (10).
Calc‘n‘Clean in progress
The descaling pro gramme now runs for
about 30 seconds and rinses the appliance.
Push milk frother
● Push the milk frother (6) in to close it.
Calc‘n‘Clean in progress
The cleaning pro gramme will now run for
about 8 minutes.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
Replace the ilter if one is being used. The
appliance has inished cleaning is ready for
use again.
Important:
Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion. New sponge cloths may
contain salts. Salts can cause rust ilm
on stainless steel and must therefore be
washed out thoroughly before use.
Frost protection
¡
To avoid damage from low tempera-
tures during transport and storage,
the appliance must be completely
emptied irst.
Note:
The appliance must be ready for use
and the water tank (16) illed.
1. Place a large receptacle under
outlet (6c).
2. Press the
h
button (11).
The
h
button (11) lashes and the
appliance now heats up for approx.
20 seconds. The display then shows
Pull milk frother
.
3. Open the milk frother (6) by pulling
it out and release steam for about
15 seconds.
4. Switch the appliance off at the power
on/off switch
O / I
(9).
5. Empty the water tank (16) and the
drip tray (8).