Bosch VeroCafe Latte TES503 Series, Инструкция по эксплуатации

Страница: 20 / 138

16 en
Robert Bosch Hausgeräte GmbH
Descaling
Duration: approx. 25 minutes.
Important:
If there is a ilter in the water
tank (16), it needs to be removed before the
descaling programme is run.
If the message
Descale required!
appears
on the display, press the
e
off
/
j
button
(12) for 3 seconds and then press the
start
button (10). The descaling programme
will start.
To descale the appliance before being
prompted, press the
e
off
/
j
button (12) for
at least 3 seconds. Then press the
e
off
/
j
button (12) briely twice. Turn the upper
rotary knob (14) until
Start descaling
appears in the display.
To start the descaling procedure, press the
start
button (10).
The display will guide you through the
programme.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
N.B.:
If the water ilter is activated, the
display will prompt you to remove the
ilter and then press the
start
button (10)
again. Remove the ilter now if you have
not already done so. Press the
start
button (10).
Fill descaler
Press start
● Pour lukewarm water into the empty
water tank (16) up to the
0.5 l
mark and
then dissolve 1 Bosch descaling tablet
TCZ8002 in it. When using TCZ6002,
2 tablets must be dissolved.
● Press the
start
button (10).
Descale in progress
The descaling pro gramme will now run for
about 10 minutes.
Place container
Pull milk frother
● Place a receptacle with a capacity of at
least 0.5 litres under the outlet (6c).
● Pull the milk frother (6) to open it.
Descale in progress
The descaling pro gramme will now run for
about 12 minutes.
Clean / Fill water tank
Press start
● Rinse the water tank (16) and reill it with
fresh water up to the
max
mark.
● Press the
start
button (10).
Descale in progress
The descaling pro gramme now runs for
about 30 seconds and rinses the appliance.
Push milk frother
● Push the milk frother (6) in to close it.
Descale in progress
The descaling pro gramme now runs for
about 1 minute.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
Replace the ilter if one is being used. The
appliance has completed descaling and is
ready for use again.
Important:
Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion. New sponge cloths may
contain salts. Salts can cause rust ilm
on stainless steel and must therefore be
washed out thoroughly before use.