Bosch TSTBT4H2CP-M--A, Руководство пользователя

Страница: 12 / 24

6 720 220 380 Subject to change without prior notice Revised 06-13
12 TSTBT4H2CP SERIES
iniTial ThermosTaT seTTinGs
The user options can be accessed using Menu key or by
pressing certain areas on the LCD.
seleCTinG heaTinG or CoolinG
By pressing SYSTEM button, you can rotate through the 4
operation mode choices: off, heaT, emheaT, Cool,
auTo. Select off to turn both heating and cooling off.
Select heaT for heating only or Cool for cooling only.
Select auTo for automatic changeover of heating and
cooling. When used for heat pump control, the emergency
heating can be operated by selecting EmHeat.
Inside
We
Day
HEAT
Schedul e
AUTO
FAN MENU MODE NEXT ENTER
Heat
Set To
SYSTEM
AM
System
Key
seleCTinG auTo or ConT fan
Select AUTO to allow the fan to be activated when needed
by a heating or cooling call. Select CONT to operate the
fan continuously for ventilation.
Inside
We
Day
HEAT
Schedul e
AUTO
FAN MENU MODE NEXT ENTER
Heat
Set To
SYSTEM
AM
Fan Key
adjusTinG The TemPeraTure
seTTinG.
Press the

arrow to raise the temperature setting or
press the

arrow to lower the setting. To change the
non-calling system temperature setting, press the neXT
key to switch from heat to cool setting or cool to heat
setting and use the

and

arrows to set the
temperature. The mode in which the set point is being
established will be displayed underneath the set point
temperature (ie. Heat will be displayed when establishing
the set point for heating).
Inside
We
Day
HEAT
Schedul e
AUTO
FAN MENU MODE NEXT ENTER
Heat
Set To
SYSTEM
AM
Up/Down
Keys
adjusTinG rh seTPoinTs for
humidiTy ConTrol.
(Only available with TSTBT4H2CPHM--A &
TSTBT4H2CPHMW-A model thermostats)
If a thermostat has an RH sensor, use the neXT key to
select RH setting for dehumidification or humidifier
control. Use the

and

keys to raise or lower the RH
setting.
Inside
We
Day
HEAT
Schedul e
AUTO
FAN MENU MODE NEXT ENTER
Set To
SYSTEM
AM
Indoor RH
RH%
RH%
RH setting
seleCTinG oPeraTinG mode
There are four operating modes: Schedule Operation,
Temporary Hold, Permanent Hold, and Vacant Mode.
Press and hold the mode key to switch between
Schedule Operation, Temporary Hold, Permanent Hold, or
Vacant Mode.
In Schedule Operation, the temperature settings for
heating and cooling are automatically set according to the
Morning, Daytime, Evening, and Night times and
temperature settings for each day of the week. See the
schedule programming section above on instructions how
to establish temperature set points and time of day that
each program will apply.
The Temporary Hold mode is activated when the

or

keys are pressed to adjust the temperature setting during
the schedule operation. “TempHold” will be displayed
instead of “Schedule” for the duration for the temporary
set point once the back light has dimmed. The
temperature settings are held for 3 hours and then will
resume with the normal schedule settings for that specific
time of day.
initial Thermostat settings