Operating the Dishwasher
en-us
29
Auto power off
This setting determines the length of
time the control panel stays
illuminated after the cycle is
complete. To save energy the
recommended setting is
˜
:
‹‚
.
This setting can be adjusted from
˜
:
‹‹
to
˜
:
‹ƒ
.
To change the setting:
1.
Press the
On/Off
button
(
.
2.
Hold down the function key
#
and press the
Start
button
P
until the display
8
indicates
š
:
‹
x (x can be any number).
3.
Release both buttons.
4.
Press the function key
#
until
the display
8
indicates
˜
:
‹
x.
5.
Press the function key
3
until
the display corresponds with your
requirements.
6.
Press the
Start
button
P
.
Switching off the appliance
Short time after the end of the wash
cycle:
1.
Open the door.
2.
Switch off On/Off button
(
.
3.
Turn off water supply.
4.
Remove the utensils when they
have cooled down.
9
WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Interrupting the wash cycle
9
CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
1.
Open the door.
2.
Switch off On/Off switch
(
.
The LED’s go out. The wash cycle
is saved.
3.
To continue the wash cycle,
switch on the On/Off switch
(
again.
4.
Close the door.
Note:
Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
˜
:
‹‹
dishwasher does not turn off
automatically
˜
:
‹‚
dishwasher turns off
automatically after 1 minute
˜
:
‹ƒ
dishwasher turns off
automatically after
120 minutes (2 hours)
Содержание SHPM78W54N
Страница 2: ...2 ...