en-us
Operating the Dishwasher
40
Auto power off
This setting determines the length of
time the control panel stays
illuminated after the cycle is
complete.
To save energy, the recommended
setting is “after one minute”.
Possible settings are:
■
off:
The appliance does not
switch off automatically.
■
After one minute:
The appliance
switches off after 1 minute. This is
the most energy efficient setting.
■
After two hours:
The appliance
switches off after 2 hours.
Tone volume
The end of the wash cycle is
indicated by a buzzer. You can also
change this setting.
Button volume
When you are operating the
dishwasher, a signal sounds
whenever a button is pressed. You
can control the volume of the signal.
If you do not like the button volume,
you can switch it off.
Greeting
When you switch on the dishwasher,
the brand logo appears. You can
switch off the brand logo.
Factory setting
You can reset all settings to the
factory setting.
Switching the appliance on
1.
Turn the water supply on fully.
2.
Open the door.
3.
Switch on
On/Off
switch
(
.
The
Auto
wash cycle has been
preset as a default whenever the
appliance starts. This wash cycle
remains selected if no other wash
cycle button
0
is pressed.
4.
Press
Start
button
)"
.
5.
Close the door.
Wash cycle sequence starts.
Note:
Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
Delay start time
You can delay the start of the wash
cycle by up to 24 hours. Depending
on the setting of the time display, the
end of cycle is indicated with “Finish
in” (for example 3h 25m) or “Finish
at” (for example 15:20 hours).
1.
Open the door.
2.
Switch on
On/Off
switch
(
.
3.
Select wash cycle
0
.
4.
Press
Delay
start button
`
.
5.
Keep pressing the setting buttons
+ -
X
until the displayed time
corresponds with your
requirements.
6.
Press
Start
button
)"
, timer
programming is activated.
7.
To delete the Delay start time,
press
Start
button
)"
for about
3 seconds.
8.
Close the door.