en-us
Operating the Dishwasher
42
Interrupting the wash cycle
9
CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
1.
Open the door.
2.
Switch off On/Off switch
(
.
The LED’s go out. The wash cycle
is saved.
3.
To continue the wash cycle,
switch on the On/Off switch
(
again.
4.
Close the door.
Note:
Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
Cancel a cycle (reset)
1.
Open the door and press and
hold the
Start
button
)"
for
approximately 3 seconds until the
digital display
@
shows:
"Program was terminated".
2.
Close the door.
3.
Wait about 1 minute while the
dishwasher drains.
4.
Open the door and press the
On/Off
switch
(
.
Changing the wash cycle
When the
Start
button
(
has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).