Bosch Rexroth IndraDyn S MS2N, Руководство по эксплуатации

Страница: 46 / 118

Malfunction in case of exceeded tolerance of
the rated voltage (switching voltage)
CAUTION
For safe switching of the holding brake, a rated voltage of 24 V DC ±10% is re-
quired at the motor.
Ensure correct dimensioning of the supply wires (wire length and cross-section)
for the holding brake.
The control voltage can be reduced using the energy saving function after safely
releasing the brake, see chapter "Energy saving function for holding brakes" on
page 25 .
Protective circuit
The holding brakes are intended for direct connection to the IndraDrive control-
ler. A protective circuit to switch inductive loads of holding brakes is integrated
in IndraDrive controllers. Please observe when operating of third-party convert-
ers that MS2N motors do not have an integrated protective circuit.
Technical data holding brakes
MS2N 03 04 05 06 07 10
Brake 1 1 1 1 2 1 2 1 2 3
Static holding torque
M4 [Nm] 1.8 5.0 10 10 15 20 36 33 53 90
Dynamic braking torque
M
1
[Nm]
1.3 4.5 4.5 4.5 11 12.5 16.5 16.5 23 33
Rated voltage
U
N
[V]
24
Rated current I
N
[A] 0.46 0.63 0.73 0.73 0.65 0.78 0.94 0.94 1.0 1.5
Connection time
t
1
[ms]
8 30 30 30 29 40 60 60 50 65
Disconnection time t
2
[ms] 35 45 80 80 130 100 200 200 220 250
Maximum switched energy
W
max
[J]
300 400 400 400 888 340 850 850 850 1470
Tab. 4-8: Technical data of holding brake
Bosch Rexroth AG
About this product MS2N Synchronous Motors
24/95
DOK-MOTOR*-MS2N*******-IT03-EN-P