28/56
Press modules Type IH04
| Assembly
Bosch Rexroth AG, Edition 08.2021, RE 63124-B
▶ Take precautions preventing the kinking of hoses.
▶ Make sure that the smallest bending radius is above the minimum bending radius
of the respective hose.
If the minimum bending radius is not reached, the hose can kink and narrow
in cross-section or even be squeezed, which prevents the hydraulic fluid from
flowing out. This may result in excessive stress. This may reduce the working life
of the hose or result in its failure.
Proceed as follows to hydraulically connect the press module:
1.
Depressurize the relevant system part.
2.
Establish all connections observing the hydraulic circuit diagrams of the
machine/system.
3.
Make sure that pipes and/or hoses are connected to all ports and/or that the
ports are closed with plug screws.
4.
Carry out a special check to make sure that the cap nuts and flanges are correctly
tightened at the pipe fittings and flanges.
5.
Make sure that all pipe and hose lines and every combination of connection
pieces, couplings or connection points with hoses or pipes are checked for their
operational safety by a person with appropriate knowledge and experience.
Smallest admissible
bending radius
of hose lines
Installation procedure