Bosch Rexroth CytroMotion, Руководство по эксплуатации

Страница: 37 / 60

37 / 60
Self-contained axis
General information
Bosch Rexroth AG RE62290-B, 05.22
8 Commissioning
8.1 General information
WARNING
Working in the danger zone! Serious injury due to
improper work.
−
Pay attention to potential sources of danger and
remove them before commissioning the self-con-
tained axis.
−
No persons may be within the danger zone of the
self-contained axis.
−
Do not touch the area of the cylinder unit.
−
The electrical commissioning has to be carried out or
supervised by an specialized electrician.
WARNING
Uncontrolled system behavior! Electrical connections
which are not connected may cause malfunctions which
may lead to injuries.
−
Commission the self-contained axis only if it is com-
pletely installed.
NOTICE
Condensed water in electrical components! Risk of
short-circuit!
−
Let the electrical components acclimatize themselves
for several hours as otherwise, condensed water may
lead to problems.
The individual partial steps for commissioning are:
1.
Assessment of the mechanical and electrical assembly and wiring work
●
Carry out a visual inspection of the self-contained axis and the asso-
ciated operating media in the control cabinet to check for obvious
defects.
●
Correct any damage detected.
●
Determine whether the protection against direct contact with active
parts is present and that the protective measures for indirect con-
tact are not faulty. Check the cross section, installation, connection
and marking of protective conductors, earth conductors and potential
equalization conductors.
●
Check the interface control on the side of the self-contained axis and
also on the customer system side.
2. Measurement / quality control of the supply voltages
3. Checking of the emergency off devices, insulation monitoring, safeguards
and reporting and display features.
4. Controlled commissioning of the self-contained axis by switch-on or acti-
vation of switching circuits in the control cabinet
5. Checking for functionally and correct connection of valve technology,
sensor technology, position measurement system, etc.
The stepped re-commissioning of the self-contained axis after a malfunction
has been remedied is always to be agreed with Bosch Rexroth.