16
/24
4THE5
| Installation
Bosch Rexroth AG, RE 29696-01-B/2021-06-15
7 Installation
Prior to installation, the following documents should be to hand:
• Data sheet of the product (contains the permissible technical data,
main dimensions and installation drawing)
7�1 Unpacking
NOTICE!
Danger due to electrostatic discharge!
When unpacking the joystick, there is a danger of damage to the electronic
components of the joystick due to electrostatic discharge.
▶ During unpacking, the joystick is to be protected against electrostatic discharge.
▶ Remove the packaging from the joystick.
▶ Check the joystick for transport damage and completeness, see chapter 4
"Scope of delivery" on page 12.
▶ Dispose of the packaging in accordance with the regulations in your country.
7�2 Installation conditions
The installation position and position of the joystick essentially determine the
procedures for installation and commissioning.
▶ Do not install the joystick close to parts that generate considerable heat
(e.g. exhaust).
▶ Lines are to be routed with sufficient distance from hot or moving vehicle parts.
▶ A sufficient distance to radio systems must be maintained.
▶ Before electric welding and painting operations, the joystick must be
disconnected from the power supply and the joystick connector must be
removed.
▶ Cables/wires must be equipped with an individual seal to prevent water from
entering the connector.
7�3 Installing the joystick
7�3�1 Preparation
1�
Use the material number on the sticker of the packaging unit or directly on
the product to check whether the correct joystick is available, see chapter 4
"Scope of delivery" on page 12.
2�
Compare the material number with the details in the order confirmation.
If the material number of the joystick does not match the one in the order
confirmation, contact your local contact person for clarification. You can find
their contact information at
www.boschrexroth.com/addresses
7�3�2 General instructions
Please refer to data sheet 29696 or 29697.
