Bosch radion rfrc-opt, Справочное руководство

Страница: 11 / 54

– As a consumer, you are legally obliged to take batteries to a suitable collection point.
– You can return used batteries free of charge to the point of sales or to a communal
collection point.
– Batteries can contain substances that are hazardous to the environment or health.
– Only dispose of discharged batteries in the container provided and, in the case of lithium
batteries, mask the poles.
Batteries are identified with a crossed out trash can symbol.
If the batteries contain specific harmful substances, the chemical symbols are also indicated:
–
Cd - Cadmium
– Pb - Lead
– Hg - Mercury
RFRC-OPT Installation
Use the provided anchors and screws to mount the receiver in locations accessible for future
maintenance. Mount the receiver onto a wall.
For best receiver reception results, place the receiver in a central location among the
transmitters. For optimal communication results in situations where there is a long distance
between the transmitting device and the system receiver, it might be necessary to install
repeaters.
Notice!
Mount the receiver in a location away from metal objects. Metal objects (duct work, wire
mesh screens, boxes) reduce RF range.
RFRC-OPT configuration
RADION Wireless System operates on a radio frequency of 433.42 MHz.
Configuring the address switch
The address switch determines the receiver’s numeric address value which the receiver will
use to report receiver status information to the control panel. Set the address to the receiver
prior to installation. Address 1 through 8 are valid address settings for the receiver. Use a
slotted screwdriver to set the address switch.
Address settings
The receiver address switches provide a single-digit setting for the receiver’s address. The
receiver uses addresses 1 through 8. Addresses 0 and 9 are invalid and will cause the receiver
to enter into an Option bus communication error state. This will cause the receiver to be
unrecognized by the control panel. Refer to your control panel documentation for information
on the valid addresses for that control panel. The figure below shows the address switch
setting for address 1.
3.2
3.2.1
RADION receiver OP RADION receiver OP | en 11
Bosch Security Systems, Inc Reference Guide 02.2014 | 01 | F.01U.261.835