Bosch MOT 240, Руководство по эксплуатации

Страница: 63 / 236

63
Plug-in sockets 2 and 9: Adapter 1 687 023 147 for reference
mark generator (the adapter is a special accessory and must be
ordered separately). Use to measure the ignition time/ignition
advance of vehicles without ignition mark or TDC mark and
without TDC sensor. The marker is connected to the reference
mark generator of the engine electronic system with appropriate
connecting cables or adapters and supplies a pulse which is
processed by the TDC sensor input of the MOT.
No. Designation Application
1. 15-pin sensor Connection to plug-in
connector with socket 2
electronic
measuring system
2. 6-pin connector Connection to plug-in socket 9
(TDC sensor connection)
3. 6-pin socket To plug in connecting/adapter
cables
– Connecting/adapter To connect to vehicle
cables (reference mark generator
for engine electronic system)
Plug-in socket 3: Clamp-on pickup 1000 A. For the measurement
with the corresponding cable of the measuring point, e.j.:
connecting to the load cable, the starter cable.
No. Designation Application
1. Sensor connector Connection to the plug-in
with 15 pins socket 3
2. Clamp-on pickup through the cable of the
measuring point
Plug-in socket 3: Clamp-on pickup 20 A: 1 687 224 734 (The
clamp-on pickup is a special accessory and must be ordered
separately). For the measurement with the corresponding cable
of the measuring point, e.j.: connecting to the load cable, the
supply cable to the idle actuator or the supply cable to the ignition
coil.
No. Designation Application
1. Sensor connector Connection to the plug-in
with 15 pins socket 3
2. Clamp-on pickup through the cable of the
measuring point
Plug-in socket 3: Current measuring shunt 500 mA:
1 684 503 024 (The current measuring shunt is a special
accessory and must be ordered separately). For the measure-
ment detach the cable of the measuring point and insert the
current measuring shunt.
No. Designation Application
1. Sensor connector Connection to the plug-in
with 15 pins socket 3
2. Current measuring Insert into the cable
shunt with
appropriate
measuring clamps
2
3
1