User Manual | Mitchell Diagnostics | Scan Tool | 22 | en
©Mitchell International, Inc.
581624 | REV. B | 06.2017 | APDMD032018
Non-Continuous Tests
Mode 6 views onboard monitoring test results for
noncontinuous monitor systems.
Generic OBDII
READINESS MODE 1
DATA STREAM MODE 1
FREEZE FRAME MODE 2
O2 SENSORS MODE 5
SPECIAL TESTS MODE 8
NON-CONTINUOUS TESTS
MODE 6
DTCs MODES 3, 4, 7, A
VEHICLE INFO MODE 9
Menu
Share
Non-Continuously Monitored Tests
(Mode 6)
Component parameters may not be valid if Readiness Status is
‘Not Ready’.
OK
Cancel
ss02725
1. Select Non-Continuous Tests from the Generic
OBDII screen.
2. Follow the prompts on the screen.
Generic OBDII
READINESS MODE 1
DATA STREAM MODE 1
FREEZE FRAME MODE 2
O2 SENSORS MODE 5
SPECIAL TESTS MODE 8
NON-CONTINUOUS TESTS
MODE 6
DTCs MODES 3, 4, 7, A
VEHICLE INFO MODE 9
Menu
Share
Non-Continuously Monitored Tests
(Mode 6)
Failed
UNITS
N/A
N/A
MIN
MAX
TID 1
CID 1
TID 1
TID 1
28832
VALUE
31744
ECU: ENGINE
Failed
UNITS
N/A
N/A
MIN
MAX
TID 2
CID 2
TID 2
TID 2
28832
VALUE
31744
ss02726
Non-Continuous Monitor Tests (Mode 6) are a pass/
fail test. Some examples are certain EVAP tests,
catalyst, and EGR. The following information is
reported:
• ECU.
• TID (test identification) which indicates the
system monitor.
• CID (component identification) which indicates
the component tested and its test value.
• Minimum value, maximum value, and current
value for each non-continuous monitor
supported.
• Pass or fail test results.
Each vehicle manufacturer assigns a code number
to their system monitors and components. Refer
to the vehicle manufacturers Mode 6 code chart
to determine the failure indicated by the TID and
CID. If this chart is not available, run an automated
system test (AST) from the DTC screen and select
Mode 6. See Read DTCs section for more information
regarding steps to complete that action.
Non-Continuous Tests Button Definitions
Menu Button
Tapping the Menu button displays a
pop-up link that takes the user to more
buttons.
View Help
Selecting View Help will open an online
user manual.
Use Metric Units
Selecting Metric Units will switch from
English/Standard Units to Metric Units.
Use English/Standard Units
Selecting English/Standard Units will
switch from Metric Units to English/Stan-
dard Units.
Take Screen Capture
Selecting Take Screen Capture will save a
copy of the current open screen.
Special Tests
Mode 8 controls the operation of an onboard
system, test, or component which is typically the
EVAP system or diesel particulate filter (DPF) test.
Generic OBDII
READINESS MODE 1
DATA STREAM MODE 1
FREEZE FRAME MODE 2
O2 SENSORS MODE 5
SPECIAL TESTS MODE 8
NON-CONTINUOUS TESTS
MODE 6
DTCs MODES 3, 4, 7, A
VEHICLE INFO MODE 9
Menu
TAP ‘SPECIAL TESTS MODE 8’ TO REOPEN
ss02727
1. Select Special Tests from the Generic OBDII screen.
SPECIAL TESTS
ALL TESTS
DPF TESTS
EVAP TESTS
DPF Tests
EVAP Tests
Diesel Particulate Filter Regeneration
Search All Special Tests
All Special Tests
Evaporative System Leak Check
Menu
ss02728